编程单个SB8F
在对传感器盒进行编程之前，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，直到READING红灯开始闪烁，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。
Before programming the sensor box, make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for3 seconds until the READING red light starts fashing, then release it.Thered light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).
配置和指标
•S1：实现选择输出信号的类型，PNP（P/2）或NPN（N）。
•S2：分别根据NPN或PNP选择（通过S1）实现选择内部PULLUP（PU）或PULL-DOWN（PD）电阻器。
•L1：通电时为绿色。
•L2：当常闭系列输出切换时为琥珀色（例如：全部触点打开）。
•L3：当切换常开系列时琥珀色（例如：全部触点闭合）。
•S1: enables the selection of the type of output signal, PNP(P/2) or NPN (N).
•S2: enables the selection of internal PULL-UP (PU) or PULLDOWN(PD) resistors depending on the NPN or PNP selection(via S1), respectively.
•L1: green when powered.
•L2: amber when the NC series output is switched (e.g. allcontacts open).
•L3: amber when the NO series is switched (e.g. all contactsclosed).
双钳口自动校准平行i气动夹具(SGP-S系列)
•双动作。
•反冲调整系统。
•小尺寸高i性能。
•紧固的构造使其非常适合重型作业的运用，使用寿命长，免维护。
•不同的紧固和输送选项。
•随时用于 PRO-SN…HS (1) 可编程磁性传感器。
•食物级润滑油FDA-H1。
Double acting.• Backlash adjusting system.• High performance in small dimensions.• The rugged construction lends itself to heavy duty applicationsfor a trouble free long life without maintenance.
Various fastening and air feeding options.• Ready for PRO-SN …HS (1) programmable magnetic sensor.• Food grade grease FDA-H1.